ENDA ETC 9420 PDF

NOTE: ETC ENDA ETC series are intended for installation in control panels. Make sure that the device is used only for intended purpose. The shielding. Thank you for choosing ENDA EPC profile controller. * Selectable SSR or While cleaning the device, solvents (thinner, benzine, acid etc.) or corrosive. Double set point. Selectable sensor type (Pt, J, K, L, T, S, R). PID control function with accurate self-tuning. Digital inputs can be assigned to 3 different.

Author: Tajar Mugore
Country: Senegal
Language: English (Spanish)
Genre: Marketing
Published (Last): 7 February 2006
Pages: 291
PDF File Size: 11.49 Mb
ePub File Size: 1.85 Mb
ISBN: 284-4-61135-978-6
Downloads: 47934
Price: Free* [*Free Regsitration Required]
Uploader: Shakazragore

Difference addresses should be selected for every device.

If this parameter is 1, digital filter runs most quick. The normal value is 0. If self tune is achieved A.

If band alarm is selected, A1. Set appears on the display. The same procedure is valid for the decrement key. After 1 second following the release of the key, initial condition is returned.

Use suitable compensation cables.

The minimum value is the value of C. Adjusable between 1 and When self tune procedure begins with no failure, Pid.

  26LS33 DATASHEET PDF

Enda ETC Series PID Temperature Controllers Panel Mount | Rapid Online

CSET If key is pressed and held 0. The device must be protected against inadmissible humidity, vibrations, severe soiling and make sure that the operation temperature is not exceeded. Rnda attention to the polarities of the thermocouple cables as shown in the figure right are connected to the. During an installation, all of the cables that are connected to the device must be free of energy.

S different from out1. If endq or deviation alarm is selected, this parameter can be Lo. While cleaning the device, solvents thinner, benzine, acid etc. After PID is calculated A. If the selected input type is changed, the value of C. Process value during normal operation Mnemonic parameter code during programming SV Display: Set point during normal operation Date value during programming SET Do not use the device in locations subject to corrosive and flammable gases. Adjustable between 1 and Four kinds of functions can be selected.

Technical Specification |

While holding 25 REdY. Read this document carefully before using this device. The maximum value is the value of A1. The value of parameter should be increased in interference.

  ASUS P5S800-VM MANUAL PDF

Enda ETC Series PID Temperature Controllers Panel Mount

Using this parameter the energy requirements of the system is adjusted at the set point. If 0 is selected, soft start feature will be enable and the device reaches set point value quickly.

If independent alarm is selected, A1. RS Modbus communication None Then press any key to see Pid. If any key is pressed while P.

Technical Specification

So the set point can be achieved by minimum fluctuations and in the shortest time. If process value is Appropriate to begin self tune, rEdY. Press any key to deactivate the self-tune procedure. The installation and electrical connections must be carried on by a qualified staff and must be according to the relevant locally applicable regulations.

The maximum value is the value of A2.