Installation manual. 1. The kit includes the following parts: 1. Remove the upper part of remote controller (Refer to figure 1). Insert a minus screwdriver into the. this operation manual before using the air conditioner. It will tell See also the operation manual included with the indoor unit for details on the. You can read the recommendations in the user guide, the technical guide or the installation guide for DAIKIN BRC1D You’ll find the answers to all your.

Author: Mezigal Voshura
Country: Senegal
Language: English (Spanish)
Genre: Politics
Published (Last): 28 August 2012
Pages: 477
PDF File Size: 6.49 Mb
ePub File Size: 2.22 Mb
ISBN: 572-4-53210-993-2
Downloads: 12456
Price: Free* [*Free Regsitration Required]
Uploader: Zulkijin

Remote controller Wood screws Installation manual Wall plugs Machine screws 1.

BRC1D52 | Daikin

Remove the upper part of remote controller Refer to figure 1 Insert a minus screwdriver into the slots 1 in the lower part of the remote controller 2 placesand remove the upper part of the remote controller. Be careful not distort the shape of the lower part of remote controller by overtightening mounting screws. Reattach the upper part of the remote controller Be careful not to pinch the wiring when attaching. It’s a community-based project which helps to repair anything.


Be brc1d2 not to damage the board with the minus screwdriver. Connect the terminals on top of the upper part of the remote controller P1, P2and the terminals of the indoor unit P1, Btc1d52. Refer to figure 5.

Change setting when ultra-long filter is installed 2 Thermostat sensor in remote controller 3 Spacing time of display time to clean air filter count setting for when the filter sign is not to be displayed nrc1d52 15 25 Approx. Do not directly touch the PC board with your hand. The switch box and wiring for connection are not included.

Refer to the chapter “Field settings”.

IM BRC1D52 |

This operation is unnecessary when setting by group. Not displayed if the indoor unit is not equipped with that function.

Refer to figure 8. Permission level function 6.

P1 and P2 do not have polarity. Long life filter Approx. Do not make any settings not given in the table. The kit includes the following parts: The PC board is mounted in the upper part of the mmanual controller.


Refer to the instruction manual for each optional accessory. If required, you can limit the user action by restricting the number of operable buttons.


Wire the indoor unit 1 Refer to figure 6 NOTE indoor unit 2 lower part of the remote controller 3 upper part of manuql remote controller 4 wired from the rear 5 wired from the top 6 notch the part for the wiring to pass through with nippers, etc.

Set the remote controller before turning the power supply on.

Refer to figure 4: During this time the remote controller can not be operated. Setting is carried out in the group mode, however, if the mode number inside the parentheses is selected, indoor units can also be set individually. First begin fitting from the clips at the bottom. NOTE When wiring, run the wiring away from the power supply wiring in order to avoid receiving electric noise external noise.