SPECIFICATIONS FOR SEAMLESS BRASS TUBES AS PER ASTM- B ITEM NO. 1 TO 4: Nominal composition: Cu – 63% and Zn – 37% (Copper alloy UNS. ASTM B/BM Standard Specification for Seamless Brass Tube. standard by ASTM International, 10/01/ View all product details. Most Recent. ASTM B Standard Specification for Seamless Brass Tube. standard by ASTM International, 10/01/ View all product details. Most Recent. Track It.
|Published (Last):||26 December 2012|
|PDF File Size:||15.42 Mb|
|ePub File Size:||17.10 Mb|
|Price:||Free* [*Free Regsitration Required]|
The following copper alloys are specified and classified according to their nominal compositions: For any combination of diameter and wall thickness not covered under hard-drawn temper, the values given for drawn temper shall be used. This specification covers seamless round and rectangular including square copper alloy tube in straight lengths.
This abstract is a brief summary of the referenced standard.
ASTM B / BM – 17 Standard Specification for Seamless Brass Tube
The tempers of annealed tube shall be designated as light anneal O50 and soft anneal O It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Ten alloys are specified having the following nominal compositions: Light-drawn bending temper is used only when a tube of some stiffness but yet capable of being bent is needed.
A mercury nitrate test asrm be done to detect and remove mercury vapor. Hard-drawn temper is used only where there is need for a tube as strong as is commercially feasible for the sizes indicated. The tempers of drawn tube shall be designated as light-drawn H55drawn H58and hard-drawn H The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other.
Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard. Combining values from the two systems may result in non-conformance with the standard.
Historical Version s – view previous versions of standard. Link to Active This link will always route to the current Active version of the standard.
ASTM does b35 give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date. Mercury, or its vapor, has been demonstrated to be hazardous to health and corrosive to materials. It is informational only and not an official part of bb135 standard; the full text of the standard itself must be referred to for its use and application. Nondestructive tests such as eddy-current test, hydrostatic test, and pneumatic test shall be done as well.
Specs ASTM B135
Drawn temper is for general purposes and is most commonly used where there is no specific requirement for high strength on the one hand or for bending qualities on the other. Caution should be taken when handling mercury and mercury containing products. The tubes shall undergo mechanical tests such as tension test, Rockwell hardness test, and expansion test in order to determine certain properties such as tensile strength and hardness.
Ten alloys are specified having the following nominal compositions:. C, and UNS No.