Source ACMC direct from stocking distributors and other suppliers. Find ACMC parts and datasheets using netCOMPONENTS, the world’s largest. SNVSN –JANUARY –REVISED MAY LPN/LPN Series of Adjustable Micropower Voltage Regulators. Check for Samples: LPN. » Datasheets» Поиск ACMC. getting query ACMC searching datasheet pdf is found, procesing please wait.
|Published (Last):||24 August 2007|
|PDF File Size:||3.35 Mb|
|ePub File Size:||10.72 Mb|
|Price:||Free* [*Free Regsitration Required]|
TI has not conducted any testing other than that specifically described in the published documentation for a particular TI Resource. The capacitor can be reduced to 0. Temperature of 3 Representative Units Figure 6. Changes in output voltage due to heating effects are covered under the specification for thermal regulation. Using the adjustable versions at voltages below 5 V runs the error amplifier at lower gains so that more output capacitance is needed.
ACMC – NS – IC Chips – Kynix Semiconductor
Power electronics wikipedialookup. At very low values of programmed output voltage, the minimum input supply voltage of 2 V 2. Please consult factory for custom voltages. If the requirements are simply input voltage and acm voltage, compliance specifications such as internal power dissipation or stability must be verified to ensure a solid design. All LP devices have the nominal output voltage coded as the last two digits of the part number. Ripple Rejection Figure Linked contents are provided “AS IS” by the respective contributors.
This figure is the comparator’s built-in offset of about 60 mV divided by the 1. Voltage regulator wikipedialookup.
Stock/Availability for: 2951ACMC
Successfully implementing an LDO in an application depends on the application requirements. All other trademarks are the property of their respective owners. Place ground return connections to the input and output capacitor, and to the LDO ground pin as close to each other as possible, connected by a wide, component-side, copper surface.
A ceramic output capacitor can be used acm a series resistance is added recommended value of resistance about 0. TI and TI suppliers consider certain information to be proprietary, and thus CAS numbers and other limited information may not be available for release.
LPN Enable Transient 9. Resistive opto-isolator wikipedialookup. This function is designed for xcmc application which needs a shutdown mode to effectively enhance battery life cycle. See Typical Characteristics for line regulation versus temperature and load current. Efficiency is defined by the ratio of output voltage to input voltage because the LPN and LPN is a linear voltage regulator. Pulse-width modulation wikipedialookup. In most applications, this ground plane is necessary to acmcc thermal requirements.
One such feature is an error flag output which warns of a low output voltage, often due to falling batteries on the input. TI has announced that the device will be discontinued, and a lifetime-buy period is in effect.
Three-phase electric power wikipedialookup. In all three of these conditions, applications with lighter load currents are more susceptible to output voltage over-shoot than applications with higher load currents. The DAP has no direct electrical wire connection to any of the eight pins. Formed lead option available in tape and reel or ammo pack. Output or reference voltage temperature coefficient is defined as the worst case voltage change divided by the total temperature range.
A second feature is the logic-compatible shutdown input which enables the regulator to be switched on and off. Dropout Voltage Figure The thermal time-constant of the semiconductor die is fairly short, and thus the output cycles on and off at a high rate when thermal shutdown is reached until the power dissipation is reduced.
Efforts are underway to better integrate information from third parties.
At power-up, with the input voltage rising faster than output stage can charge the output capacitor. Page numbers for previous xcmc may differ from page numbers in the current version.
The resistor is not required if this output is unused. Ground or leave open if shutdown feature is not to be used. Finish options are separated by a vertical ruled line.
Shutdown Threshold Voltage Figure Lead dimensions are not controlled within this area.